Common knowledge of chain saw the difference between chainsaw and air saw

Chain saw is one of the most widely used and frequently used power tools in many gardening products. Someone asked me if I did not know whether to buy a chain saw or a chain saw. What is the difference between a chain saw and a chainsaw? In fact, this is very simple for you today, it can summarize several common problems of chainsaw.

What is the difference between chain saw, chain saw, chain saw and pneumatic saw?

Chainsaws, also known as "chainsaws" chainsaws, are driven by electricity and are used to cut wood, stone, steel, etc. cutting tools with sharp teeth on their edges. Split and handheld saw blades are usually made of steel, round, ribbon and chain.

The chain saw is a chain saw. There is no difference between the two. Gasoline-powered hand saws are mainly used for logging and wood production. Its working principle is to perform the shearing action by the lateral movement of the large blade interwoven on the saw chain.

An air saw is a pneumatic tool that uses air as power to cut wood, plastic and other materials.

Buy a chain saw or a chain saw and cut down trees?

The chain saw has a relatively high power and is both sturdy and durable, but it is troublesome to maintain. The chainsaw is easy to operate and has low noise, but it is expensive. If the workload is relatively large, consider using a chain saw. If the workload is not particularly heavy or family, please choose a chainsaw. Now with a charging saw, the battery can meet the demand, but the cost is relatively high. Chain saws are cheap and durable. . The Krep chain saw is cost-effective, saves fuel, saves time and has strong horsepower.

How does the chain saw oil pump work?

The working principle of the chain saw oil pump: the worm rod drives the turbine to rotate, and uses the volume ratio principle to form a negative pressure in the oil tank. Under the action of atmospheric pressure, the oil is pressed into the oil pipe and transported to the chain saw between the guide plate and the chain. The oil pump component is an important part of the lubrication system of the two-stroke chain saw. It provides oil for the chain and the guide, allowing it to run at high speed to prevent excessive heat generation during operation, which can cause the chain guide of the chain saw to overheat and reduce work efficiency. The lubrication task of the chain saw engine is accomplished by the two-stroke oil in the fuel.

How to disassemble the chain saw flywheel?

That is a reverse thread. You can use a hammer to move the clutch spring block counterclockwise. Normally, the wire saw seal will be screwed onto the thread of the chain saw. It is best to bake with a hot air gun. This one is better.

Why is the chainsaw easy to start after a certain period of time after the throttle is turned on, and the flame is extinguished?

This is the case of high temperature flameout. First check the pressure of the lower cylinder. If the cylinder is pulled slightly, check the carburetor and fuel tank filter for dirt. If it is dirty, replace it.

How to install logging chain?

First remove the fixing plate, loosen the saw chain fixing bolts and install them. After installation, tighten the fixing bolts to the saw chain to facilitate pulling. Remember the direction when deleting, otherwise the operation must be repeated.

What is the reason why it is difficult to start again after the chain saw is turned off at high speed?

It should be no problem with cold start. If it is difficult to restart after high-speed flameout, it may pull the cylinder. You must go to a professional repair shop or contact the after-sales to replace the piston and cylinder.

The reason is: when the engine starts, the heat rises and there is a gap between the piston and the cylinder. After expansion, the engine's airless state cannot absorb enough oil and air. Although ignitable, thin oil and natural gas will produce higher levels. The temperature causes a large gap; at the same time, the thermal expansion thrust after ignition will also disappear from the gap, resulting in insufficient thrust of the piston, reduced power, and finally double-layer stacking to cause flameout.