Care and attention to the chain saw

Please distribute strictly according to the distribution of engine oil. It is best to use mixed oils for current purposes. Do not use blending oil that has been left for a long time. Before the machine runs, run at low speed for a few minutes to see if it is lubricated by the chain oil and becomes an oil pipe. Then work again. When the machine is working, the throttle is used at high speed. Each time a box of oil works, it should be allowed to stand for 10 minutes.

After each work, please clean the diffuser of the machine to ensure heat dissipation. The spark plug should be removed every 25 hours of use. Use a wire brush to remove dust from the electrode and adjust the electrode gap to 0.6. -0.7mm is better; the air cleaner removes dust every 25 hours, and the dust should be removed more frequently. Clean the foam filter with gasoline or washing liquid and clean water, squeeze it and dry it, then immerse it in the oil and squeeze out the excess oil for installation. If you print "no oil", no oil is required. Every 50 hours of use of the muffler, please remove the muffler and clean the carbon deposits on the outlet and muffler outlet. The fuel filter (suction tip) removes impurities every 25 hours.

When using new parts of the tool, pay attention to the tightness of the saw chain to facilitate the rotation of the saw chain. It is recommended to use a hand-held saw chain whose guide teeth are parallel to the guide plate. After a few minutes, please pay attention to tighten the saw chain again.

Before safe work, people or animals are not allowed to move within 20 meters. Make sure to check the grass for any debris, stones, etc. and remove the debris from the grass.

During storage, it is necessary to clean the body, release the mixed fuel, and burn the fuel in the carburetor; remove the spark plug, add 1-2 ml of two-stroke oil to the cylinder, pull the starter 2-3 times, and then install Spark plug.